Penggunaan Pelat Pengaku Kolom Pada Portal Baja

Supriyatiningsih Supriyatiningsih
* Politeknik Negeri Banjarmasin

DOI: https://doi.org/10.14421/ilj.2021.090101

Abstract


Research on the use of column stiffening plates in the construction of steel portals was carried out in order to determine the effect on loads and deflection. The part of the column that is most prone to failure is in the tensile area, namely the part of the column that is adjacent to the top of the roof beam and in the compression area at the bottom of the roof beam. The tensile part will usually fail to tear while the compressive area occurs when buckling occurs. Tearing and bending failure can be anticipated by installing stiffening plates in the column. Column stiffening plates were varied in the tensile (top), shear (middle), press (bottom), and diagonal areas between the shear-pull areas.

The loading is in the form of a concentrated load spread over fourteen points on the roof beam. The loading is carried out in 100 stages (100 sub steps) in order to get a tight iteration so as to get the best results. The optimum model can be determined after testing the five models with variations in the column stiffener plate with the largest load that can be borne by the model. The position of the importance of installing the column stiffener plate can also be found.

Keywords


column stiffening plate; load; deflection

Full Text:

PDF

References


Badan Standardisasi Nasional, 2000. SNI 03-1729-2002, Tata Cara Perencanaan Struktur Baja Untuk Bangunan Gedung, , Puslitbang, Bandung.

Badan Standardisasi Nasional, 2013. SNI 1727-2013, Beban Minimum Untuk Perancangan Bangunan Gedung dan Struktur Lain, Puslitbang, Jakarta.

Departemen Pekerjaan Umum. 1987. SKBI 1.3.53.1987, Pedoman Perencanaan Pembebanan Untuk Rumah dan Gedung, Jakarta.

Malik, A.S. 2006. Details For Portal Frames Using Rolled Sections, Plastic Design of Portal Frame to Eurocode 3, University of Sheffield SS051a-EN-EU.

Supriyatiningsih. 2016. Permodelan Elemen Hingga 3D Eaves Connection pada Steel Gable Frame, Fakultas Teknik Universitas Lambung Mangkurat, Banjarmasin.

Widodo, Mc. P. 1992. Struktur Baja: Desain dan Perilaku, Penerbit PT Gramedia Pustaka Utama, Jakarta, terjemahan dari buku Salmon C.G., Johnson J.E. 1990, Steel Structures: Design and Behavior, Emphasizing Load and Resistance Factor Design, Third Edition, HarperCollins Publisher Inc.


Refbacks

  • There are currently no refbacks.




 

Creative Commons License
Integrated Lab Journal is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.